r_rmse

(raw) #1

What does this do exactly?

Is it so bad that it needs to be restricted by pb to “0” ?

The reason i ask is because teh cb ladder has r_rmse forced to “0” when in the readme its says it causes errors at 120.

Would it be safe at say 60?

(uglok) #2

If rmse is set to a certain level then the branches of trees disappear, and you only see the stalks. So thats why its banned.

(raw) #3

thats at r_rmse “120” tho, 60 should be ok?

(k1ll3r) #4

I disagree with it being limited at 0 too… I’ve always used it @ 75 and tree leaves don’t vanish… And I do get a 20-35 FPS boost and a good gameplay (not choppy)…

(RivrStyx) #5

0 is fine to restrict it at… theres no point of it being anything but 0…even just a little bit. From what i hear is you don’t get a fps boost at all…but a drop

(raw) #6

Well im guessing you heard wrong :confused:

If you actually tried it you will see, i set it at 60 and timedemo’d and i got a 24 fps increase, to an entire 71 fps :smiley:

24 fps is obviously quite a lot when you have very little to start with.

Hopefully my upgrade parts be here soon so i wont be restricted to running my pc at shite speeds to play et, so i wont have shite fps :wink: