square

(Wolfmapper) #1

Hi,

I have create some walls in my room, but i want to cut an square in my wall. to create an MG42, but with clipping can i select only 3 corners, but i need a square!

can somebody tell me how to cut an square in my wall???

Thanks :slight_smile:

(lennyballa) #2
  1. You make a small square brush and cut.
  2. You make 4 brushes

1111111
2 4
2 4
2 4
3333333

like this

(Wolfmapper) #3

i dont uderstand it, i want a little window, for my mg42… that what i want to cut out my brush!

(Shallow) #4

At its most basic level, building with brushes is a bit like building with Lego. Think of your window in those terms and it should be obvious.

I strongly suggest you go and find a set of newbie tutorials and work through them, before you ask too many questions that you’ll find very embarassing to have asked in future :slight_smile:

(Wolfmapper) #5

I know that, but i’ve think, there must be an easieer manner, but it

doesn’t!

(MuffinMan) #6

go to www.wolfensteinx.com/surface

(fidel castro) #7

just rebuild thewall with more than one brush…into a wall out of 4 brushes

11111111111111
2222 33333
44444444444444

each new number for a brush

or just make a new Brush into your old on & cut it out.

greez
fidel

(AdamTheBastard) #8

if you REALLY can’t figure out how to do it like these other people are sugesting. Make a brush that is the same size as the window you want. place it in the wall where you want the window and (with the new brush still selected) press the “CSG Subtract” button on the tool bar up top. Deletem the brush that we were just using and there is your window.

(Wolfmapper) #9

Thanks all!