reading the compile prompt

(Mammoth Entertainment Inc) #1

hey you know the promp window that opens up when you compile, and it cloese when its done. is there anyway to read what it says after the compile is done, or to make it so it does not close when it is done. Cause i need to read it sometimes, like when i get errors or to check counts. Thanks

(EB) #2

You can turn logging on in the ‘edit’ toolbar with ‘preferences’ -> ‘bsp monitoring’ -> and it will show in the default log.

(Mammoth Entertainment Inc) #3

i had these already checked

  • Enable BSP Process Monitoring
  • Stop Compilation on Leak
  • Texturing Compatible with Q3map2

ones that are unchecked are

  • Run engine ater compile (is this the one you were talkin about)
  • Activate sleep mode when running compile

itm gith help taht i am running 1.4 not 1.5

(Ifurita) #4

you can also scroll up in the bottom most window, the Console Window, of your Radiant screen

(EB) #5

He has a different layout, I saw a pic in his other post about caulk. Mr. J., if you set your layout back to default it will be easier for you to locate the .bsp monitoring log. The picture above is the default setup.
Go into 'preferences again and select the first clickable in LAYOUT.

(Mammoth Entertainment Inc) #6

ok… :frowning:

(The Wanderer) #7

press “O”