radiant crashes when trying to compile

(TIHan) #1

hi… i am new to the forums, nice to meet u all.

i have a problem with gtk radiant 1.3.8-et, it seems to be crashes when i try to compile, sometimes it wont, sometimes it will, i have restarted my computer, reinstalled then restarted, redownload, installed, uninstalled, u name i have done it, and it still crashes, sometimes it wont and sometimes it will, why is this? :???:

(Slippery Jim) #2

In the dox it says even though your vid card/computer can run ET it is no promise that it can run the editor.

Go figure.

(fat boost) #3

this happens to me too, it says (insert name of map) can’t be found.

(TIHan) #4

ok, so it wont work with a geforce 4 ti 4400 correctly?

(Cygnus X-1) #5

“this happens to me too, it says (insert name of map) can’t be found.”

Make sure you’re running sv_pure 0 when running your maps, or it won’t load them.

(VandalL) #6

same here:

go check FILE->Project Settings:

fix basepath (check the Slashes, there where doubles - but dont foget: *nix Style Slashes) and Menu commands if needed.

did it for me

V

(Slippery Jim) #7

ok, so it wont work with a geforce 4 ti 4400 correctly?

Nope. Crap vid card. Should have went for 4600.

Joking.

(Jack) #8

Nope, not any better with the 4600.

Should have seen this coming when I tried out the 1.3.9 beta release last week. The 1.3.8 beta release a few months ago was bad…The whole 1.3.x release is evil.

For now, back to 1.2.13