QuArK

(@uzingLG) #1

Hi!
How to configurate QuArK for Q3MAP2? Are there any tutorials?

(Freshmeat) #2

No, but you download q3map2, unzip into directory under q3, and in configuration -> Quake3 you point quark to the .exe.

QuArK works out fine with q3map2, however I have had some problems doing terrain. I am not sure what it is, but I seem to get better results by compiling these with q3map2build

-Freshmeat

(@uzingLG) #3

Only Q3MAP2.exe, with no additions?

(Freshmeat) #4

unzip into directory.

You download the entire zipfile and unzip it. Further, there are a few lines that needs to be changed in two of your standard shaders (terrain and terrain2), but that goes for all q3map2 users.

-Freshmeat

(@uzingLG) #5

I meant the QuArK configuration. Only Q3MAP2.EXE instead the three Q3MAP.EXE callls and the BSPC.EXE call?

(Freshmeat) #6

q3map2 instead of q3map, and remember to set up your directories right. BSPC call stays at it is.

-Freshmeat (Was away for a while)