When running the BSP fase, after it says it’s writing the .prt file, I get a long list of the following message: “inside: 3x3”, or “inside: 9x3” or other numbers. What does this mean? Is it good, is it bad, am I breaking something? 
q3map2 2.3.35 messages?
r3tina
(r3tina)
#1
r3tina
(r3tina)
#2
Anyone? The same stuff appears in .36 too. It also seems BSP is a lot slower than .33?
ydnar
(ydnar)
#3
Ah, whoops. That’s some debug stuff I left in there for fixing patches being chopped by fog brushes.
What part of the BSP process seems slower to you, the loading of the map or something past that? Is this on a very large map?
y
r3tina
(r3tina)
#4
The part that seems slower is after the “# leafs filled” message, when all those debug messages appear. I tested it with .36 and .33, and .36 took 80 secs., while .33 took about 60.
It’s a fairly large map, 6000+ brushes, with quite a bit of small detailed stuff in it.